High-powered brushless systems are not for beginners.  High power, high DC voltages and high amperages used in these systems can result in serious damage or injury if not used properly.

APD 200F3x ESC

$289.00

SPECIFICATIONS:

The improved F_Series 200F3[X] ESCs. Building upon our trusted ARM 32-bit architecture, the V2 release features introduce a number of highly requested features into the product range, including configuration options and additional drive modes. The 200F3[X]v2 ESCs are drop-in replaceable to 200F3[X] units. As before, existing features include PWM-frequency dithering and Active Phase-Current Demagnetisation, allowing for smooth control with virtually all powertrain combinations with peak power outputs of up to 18 kW.

New Feature Set (V2)

Configuration of drive parameters, signal types and fault handling

Bi-Directional DShot for RPM Filtering support

On board bootloader

Passthrough firmware updating and configuration

Additional Telemetry types: PWM Telemetry and RPM Output

High-speed telemetry rates when operating DShot and ProShot

Reversible operation support (full forwards to full reverse)

Dynamic signal quality checks across supported input protocols

Hardware protection for UART programming pins

Existing Feature Set

Designed and manufactured in Australia using only the highest quality components, ensuring no sacrifice in reliability

Proprietary firmware designed in Australia

Plug and play firmware

Up to 12S (50.4 V) capable

Up to 120 A continuous* output current

200 A Burst current

True 10-bit resolution

Virtually no setup time, with a simple motor reverse solder tab

Auto-detect ProShot or DShot

ProShot1000 capable (1Mbs/s)

DShot150 to DShot600 capable (0.15-0.6Mbs/s)

Up to 750,000 eRPM (protocol dependant)

Motor agnostic

Auto PWM output frequency

Auto timing advance

Telemetry output

Automatic current limiting and over-temperature protection

LED indication

Digital commands over ProShot (including anti-turtle mode)

Digital commands over DShot

Bare-PCB design to allow maximum integration within the end setup

8-Layer PCB to ensure minimal track resistance

 

* Continuous current ratings are at a 100% throttle duty cycle. Continuous rating is defined as max sustained current at 100% throttle for 60 seconds with 33 m/s of airflow.

HIGH POWER BRUSHLESS SYSTEMS AND BATTERIES CAN CAUSE SERIOUS DAMAGE AND/OR INJURIES IF NOT USED PROPERLY.  USERS ACCEPT ALL RESPONSIBILITY FOR THE SETUP, USAGE, AND POSSIBLE DAMAGES THAT MAY RESULT FROM THEIR PROJECT. THIS POWER SYSTEM IS NOT FOR BEGINNERS.

THESE VOLTAGES AND AMPERAGES CAN CAUSE SERIOUS BODILY HARM INCLUDING BURNS AND ELECTROCUTION.

 

Peak power ratings defined at 100% throttle, where bus current = phase current. Requires proper sizing of motor to load.

(*) Continuous amps defined as amperage sustainable for 180 seconds with adequate cooling to keep ESC at or below 115C

(**) Burst amps defined as amperage sustainable without damage to controller for a period of 5 (five) seconds.  Burst should not be encountered again until ESC has returned to normal temperature

(***) Weight refers solely to the circuit board and enclosure, if any.  Weight measured without any wires or connectors.

Specifications subject to change without notice.

0